Suitedget B0B4KKKFXR Kit of 250 Self Levelling Wedges For Tiling Instruction Manual
- June 15, 2024
- Suitedget
Table of Contents
Suitedget B0B4KKKFXR Kit of 250 Self Levelling Wedges For Tiling
Product Information
Specifications
- Tile gap: 2mm or more
- T-needle
- Special wrench
- Adjustment cover
Product Usage Instructions
-
Step 1: Insert the T-needle
Insert the T-needle into the tile gap of 2mm or more. -
Step 2: Rotate and clamp
Rotate the T-needle 90 degrees and clamp it tightly at the bottom of the bricks. -
Step 3: Adjust the caps
Using the special wrench, adjust the caps until the two tiles are on the same level. -
Step 4: Wait and remove
Wait for 4-6 hours for the tile glue and cement to partially dry. Then, remove the leveler. -
Step 5: Loosen and remove
Loosen the adjustment cover slowly. Rotate the T-needle 90 degrees to remove it.
FAQ (Frequently Asked Questions)
-
Q: What is the minimum tile gap required for inserting the T-needle?
A: The minimum tile gap required is 2mm or more. -
Q: How long should I wait before removing the leveler?
A: Wait for 4-6 hours for the tile glue and cement to partially dry before removing the leveler.
How To Use
- Insert the T-needle into the tile gap of 2mm or more.
- Then rotate it 90 degrees, and clamp the T-needle at the bottom of the bricks tightly.
- Adjust the caps with the special wrench until the two tiles are on the same level.
- Wait 4-6 hours and then take out the leveler when the tile glue and cement are not completely dry.
- Loosen the adjustment cover slowly, then rotate the T-needle 90 degrees to remove it.