Mythco Microphone Stand Boom Arm Mic Stand Webcam Instructions
- June 14, 2024
- Mythco
Table of Contents
Microphone Stand
User Manual
Installation of the Stand
- Unscrew the clamp so that the opening is large enough to fit over the edge of your table,
- Push the clamp all the way onto the table edge for maximum security.
- Fasten the clamp to the desk by anticlockwise turning the handle so that itis tight against the underside of the table.
- Insert the arm into the hole at the top of the clamp, and then twist the knob to tighten it once the arm direction is located. You are now ready to attach your microphone.
Note
- Make sure that the clamp sits flush on both the top and bottom surfaces of the table.
- Test that you have mounted the clamp securely by seeing if you can pull it off the edge of the table. Tables with round edges provide less security than those with square edges. If the clamp comes off easily, try reattaching it tighter and repeat the test.
- Please loosen the Knob of the Desk Mounting Clamp to rotate the stand, Do not rotate it by force, otherwise the screw threads may be damaged.
- Always make sure that your mic stand is secure and in a safe location to avoid damage to your equipment.
Application of the stand
-
Connected to Dynamic Microphone
Connect the Mic Clip (included) to the arm and attach your Dynamic Microphone. -
Connected to Condenser Microphone
Connect shock mount to the arm and attach your Condenser Microphone, Loosen the two knobs on both the arm and holder to adjust the suitable angle and height, and retighten them.
Note The Shock Mount fits for microphone with an outer diameter of 40-52mm, Not fit for Blue Yeti. -
Connected to Blue Yeti / Blue Snowball / Yeti Nano (Microphone NOT included)
Thread the 3/8″ to 5/8″ screw adapter into the mounting interface of Blue Yeti /Snowball, and then connect the microphone to the arm. Loose the knob to adjust the angle and height of your Microphone, and retighten it. -
Connected to Pop Filter (Some Models included)
Recommended installation:
Unstable installation:
Note
Under the influence of gravity, the Pop Filter has a tendency to rotate, which
makes it easy to loose between the gooseneck and the base.
Troubleshooting
It seems like that some of Blue Yeti mics have had manufacturing issues. The
mounting hole on the Yeti Mic is sometimes just a tiny fraction bigger than
the 5/8″ industry standard.
Suggestion
If your Blue Yeti microphone happens to have this issue, please use the Thread
Tape to wrap around the mounting screw adapter, to effectively increase the
thickness of the mounting screw, while still maintaining the actual screw
thread, so you can connect your Yeti.
- The picture of thread tape is only for reference, please make the object as the standard.
Adjustment of Weight Capacity
Changing the position of the screw on the arm stand can adjust the spring tension, The screw is set by default at the first level positioning hole, To increase the bearing load of the arm stand, please remove the springs first, Then loosen the screw with a cross screwdriver, pull and move it to the second level positioning hole. Tighten it and install the springs back. This can enhance the stretch strength of the external spring for bearing more weight.
Tips:
Please pull the stand apart to the maximum angle, at which time the length of
the spring is minimum, for easily removing and installing the springs back.