Jiang Su Yisin Tech LHCD ONE Bluetooth Playback Device User Manual
- June 15, 2024
- Jiang Su Yisin Tech
Table of Contents
Jiang Su Yisin Tech LHCD ONE Bluetooth Playback Device
LHDC ONE User Manual
The LHDC ONE is a device that has been evaluated to meet general RF (Radio
Frequency) exposure requirements. It is designed for portable use without any
restrictions on exposure conditions.
Caution:
Any changes or modifications made to this device that are not explicitly
approved by the manufacturer may void your authority to operate this
equipment.
This device complies with part 15 of the FCC (Federal Communications Commission) Rules. Its operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
How To Use
- Step 1: Put Your Bluetooth Audio Playback Device in Pairing Mode.
- Step 2: Plug the LHDC ONE into a USB-C port on your PC or phone. For first-time use, LHDC ONE will automatically enter pairing mode, indicated by the LED flashing in BLUE/RED.
- Step 3: Wait for your device to connect to LHDC ONE.
- If connected, the LED closer to the button will turn BLUE. Proceed to Step 5.
- If not connected, the LED will be RED. Ensure your Bluetooth audio device is in pairing mode, then proceed to Step 4.
- Step 4: Double-click the button to put LHDC ONE into pairing mode, with the LED flashing in BLUE/RED.
- If connected, the LED closer to the button will turn BLUE. Proceed to Step 5.
- If not connected, the LED will be RED. Ensure your Bluetooth audio device is in pairing mode, then repeat Step 4.
- Step 5: After your Bluetooth audio device is connected, you can enjoy audio through your Bluetooth playback device. Regardless of Bluetooth connection status, you can always enjoy audio from the 3.5mm analog audio jack.
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Caution:
Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>