BATCADDY X9R Lithium Carbon Electric Golf Caddy User Manual
- June 13, 2024
- BATCADDY
Table of Contents
BATCADDY X9R Lithium Carbon Electric Golf Caddy
Product Information
The X9 Series is a golf caddy designed to assist golfers in carrying their bags and equipment on the golf course. It comes with a pre-assembled frame, front wheel, rear wheels, an advanced Lithium-FePO4 battery, a battery charger with a power cable, an instruction manual, battery use instructions, seat installation instructions, and a remote control handset. The caddy features a power/control panel, an upper bag holder, a bag support strap, an upper frame, an upper frame locking knob, a lower handle assembly, a lower bag holder, a lower frame locking knob, a front wheel, an electronics battery socket unit, and rearwheels.
Product Usage Instructions
- Wheel Mounting: When attaching the two rear wheels, match the tread direction to the front tire. Press the small silver buttons with your index and middle fingers. Slide the wheel onto the axle and turn the wheel until it snaps into place against the interior sprocket. To release the wheel, press the silver buttons and pull the wheel off the axle.
- Opening Your Caddy: Open the Lower Arm Assembly to a vertical position and tighten the Lower Screw Assembly until tight. Note that if the screw gets stuck, loosen it and try to re-tighten carefully. Never over-tighten or force the screw as it can cause damage. Next, raise the Upper Handle Assembly to the desired height and tighten the Upper Screw Assembly to lock in the handle. To fold the caddy, reverse the process.
- Battery & Charger: Place the battery in the provided tub and only use the original supplied BATCADDY battery. Connect the battery plug to the battery socket.
- Handle Control: Press the start/stop button for about 2 seconds to turn on the caddy. The battery level indicator will light up. When the battery charge level indicator only lights up red (about 25%), it is recommended to recharge the battery. Use the speed wheel to adjust the caddy’s speed. A short press of the start/stop button stops the caddy without switching it off completely. Pressing the button again resumes the caddy’s automatic driving at the last set speed. The Timer button allows you to set a fixed speed and distance for the caddy to drive ahead.
- USB Connection: The caddy has a USB port for charging personal belongings such as GPS golf watches, smartphones, Bluetooth speakers, etc. Note that using the USB port may slightly shorten the battery’s range.
- Remote Control Operation: The caddy can be operated using the remote control handset.
PACKING LIST
- 1 – X9 Series frame pre-assembled incl. front wheel
- 2 – Rear wheels
- 1 – Advanced Lithium-FePO4 battery
- 1 – Battery Charger with power cable
- 1 – Instruction manual
- 1 – Battery Use Instructions
- 1 – Seat Installation instructions
- 1 – Remote Control Handset
Included Accessories
- Umbrella Holder
- Scorecard Holder
- Cup Holder
OVERVIEW
X9 Series
WHEEL MOUNTING
When attaching the two rear wheels, match the tread direction to the front tire. Press the small silver buttons with your index and middle fingers. Slide the wheel onto the axle and turn the wheel until it snaps into place against the interior sprocket. The first of the two notches is for the freewheel mode (small gap between axle and wheel). To release the wheel, press the silver buttons and pull the wheel off the axle.
OPENING YOUR CADDY
- Open the Lower Arm Assembly to a vertical position – Tighten the Lower Screw Assembly until tight.
- Please note that the screw can be screwed into the thread without much effort. If it gets stuck, loosen and try to re-tighten it carefully! Never over-tighten or force the screw, damage can occur.
- Next, raise the Upper Handle Assembly to desired height. Tighten the Upper Screw Assembly to lock in the handle.
- Reverse the process to fold your Batcaddy
Important: The screws must tighten easily! Never tighten with excessive force, damage can occur.
BATTERY & CHARGER
Before the first start-up, you should first fully charge the battery with the supplied charger. The battery is fully charged when the LED is green. The battery is sufficient for up to 36 holes – depending on the duration of the game and the playing conditions. A complete charging cycle takes about 3 hours.
Place the battery in the tub provided. Please only use the original supplied BATCADDY battery. Connect the battery plug to the battery socket.
CONTROL
HANDLE CONTROL
Press the start/stop button for about 2 seconds to turn on the caddy. The
battery level indicator will now start to light up. As soon as the battery
charge level indicator only lights up red (about 25%), we recommend recharging
the battery.
- With the speed wheel you can adjust the BATCADDY X9R to the desired speed. To do this, simply turn the wheel forward or back with your index finger.
- With a short press of the start/stop button, you can stop the Caddy without it switching off completely. If you press this button again, the Caddy will continue to drive automatically at the last set speed.
- With the Timer button, you can let the Caddy drive ahead at a fixed speed to a fixed distance. (1x press about 10 yards, 2x press about 20 yards, 3x press about 30 yards)
USB CONNECTION
With the USB port, personal belongings, such as GPS golf watches or
smartphones, Bluetooth speakers, etc. can be charged. The range of the battery
will slightly shortened.
Remote Control Operation
- POWER Switch: Slide up to turn on the Remote Control. Slide down to turn off. It is recommended to turn the RemoteControl off when not actively operating your Caddy. This will avoid accidental button pushes when not paying attention to your Caddy.
- LED Light: Lights up when Remote Control is turned on and a button is pushed. This indicates that the remote is sending a signal to the Caddy.
- STOPPING: The button will stop the Caddy
- GOING FORWARD: Pressing the UP BUTTON while the Caddy is standing still wil lstart the Caddy in forward motion. Pushing the UP BUTTON again will increase the Caddy’s forward speed one level. Your Caddy has 9 forward speeds. Pushing down BUTTON will lower the forward speed one level.
- GOING BACKWARD: Pressing the DOWN BUTTON while the Caddy is standing still will start the Caddy in reverse motion. Pushing the DOWN BUTTON again will increase the Caddy’s reverse speed one level. Your Caddy has 9 reverse speeds. Pushing the UPBUTTON will lower the reverse speed one level.
- TURNING RIGHT: Press and hold the RIGHT BUTTON and the Caddy will turn to the right (from a stop and while in motion) until the button is released.
- TURNING LEFT: Press and hold the LEFT BUTTON and the Caddy will turn to the left(from a stop and while in motion) until the button is released.
HOLDER
SCORECARD HOLDER
- Step 1: Remove the scorecard holder from the box and remove the bubble wrap.
- Step 2: Open the lid and loosen the two black cross screws completely.
- Step 3: Remove the curved bottom of the mounting device.
- Step 4: Place the scorecard holder on the upper bars about 2 finger widths away from the speed wheel.
- Step 5: Position the bottom of the mounting device on the bottom of the top handle, then you can easily tighten the screws.
- Step 6: Use the palm of your hand to push the bottom up so that the screws protrude over the scorecard holder.
- Step 7: Now you can tighten the two cross screws completely. Make sure that the scorecard holder is aligned horizontally.
UMBRELLA HOLDER
Turn the screen holder clockwise into the thread of the pre-assembled clamp
next to the handle. For optimal grip, rotate the umbrella holder as far as
possible clockwise. To release the tension and move the umbrella holder,
rotate counterclockwise.
AUXILIARY WHEEL
Remove the quick-release bolt from the Anti-Tip Wheel and slide the Anti-tip
wheel in the rear of the device. Subsequently, the Anti-Tip Wheel is connected
with the Quick Release bolt again.
ADJUSTING THE TRACKING OF YOUR BATCADDY
The caddy is designed to be used with cart bags. Stand bags should not be
used. Please make sure that the weight distribution of the cart golf bag on
the right and left side is approximately the same. If this is the case, you
can loosen the silver nuts a little on the front wheel on both sides. After
that, the small black nuts can be easily tightened or loosened to adjust the
axle forwards or back, realigning the front wheel. Re-tighten the silver nuts.
MODEL COMPARISON
FEATURES| X3 Sport| X4 Sport| X3R| X4R| X8R|
X9R/X9R Carbon
---|---|---|---|---|---|---
One-Click Locking Frame| ✓| | ✓| | |
Dual-Lock Z-Fold Frame| | ✓| | ✓| |
No-Lock Euro-Wave Frame| | | | | ✓|
Stealth Design Frame| | | | | | ✓
Advanced Stability Geometry| | | | | | ✓
“Forever Traed” Wheels| | | | | | ✓
Single 12V Motor| ✓| ✓| | | |
Dual 12V Motors| | | ✓| ✓| ✓|
Dual 24V Motors| | | | | | ✓
Single Handle Operation| ✓| ✓| ✓| ✓| ✓|
Upgraded Handle Electronics| | | | | | ✓
Speed Recall Cruise Control| ✓| ✓| ✓| ✓| ✓| ✓
Fully Directional Remote Control| | | ✓| ✓| ✓| ✓
Standard Battery Level Indicator| ✓| ✓| ✓| ✓| ✓|
Upgraded Battery Level Indicator| | | | | | ✓
USB Charging Port| ✓| ✓| ✓| ✓| ✓| ✓
Single Anti-Tip Whee (Upgradeable to “Mountain Slayer”)| | | ✓| ✓| |
Dual Anti-Tip Wheel (“Mountain Slayer)| | | | | ✓|
Low Profile High Performance Dual Anti-Tip Wheel| | | | | | ✓
Power-Off Freewheel| ✓| ✓| ✓| ✓| |
True Freewheel Mode| | | | | ✓| ✓
Auto-Timed Distance Control| ✓| ✓| ✓| ✓| ✓| ✓
Downhill Speed Control| | | ✓| ✓| ✓| ✓
Electronic Parking Brake| | | | | | ✓
Caddy Seat| Optional| Optional| Optional| Optional| Optional| Optional
Standard Accessory Package| ✓| ✓| ✓| ✓| ✓|
BATCADDY WEIGHTS & MEASUREMENTS
| X3 Sport| X4 Sport| X3R| X4R| X8R| X9R/X9R Carbon
---|---|---|---|---|---|---
Open Dimensions| Length: 42.0”
Width: 22.3”
Height: 39.8”
| Length: 45.0”
Width: 23.5”
*Height: 36-44”
| Length: 42.0”
Width: 25.5”
Height: 37.5”
| Length: 45.0”
Width: 23.5”
*Height: 36-44”
| Length: 45.0”
Width: 23.5”
*Height: 36-44”
| Length: 44.0”
Width: 26.0”
*Height: 36-46”
Folded Dimensions| Length: 30.0”
Width: 22.3”
Height: 15.3”
| Length: 33.0”
Width: 23.5”
Height: 13.0”
| Length: 37.0”
Width: 25.5”
Height: 13.5”
| Length: 38.0”
Width: 23.5”
Height: 14.0
| Length: 36.0”
Width: 23.5”
Height: 13.0”
| Length: 35.0”
Width: 26.0”
Height: 12.5”
Shipping Box Measurements| Length: 36.0”
Width: 21.0”
Height: 13.0”
| Length: 33.0”
Width: 24.0”
Height: 11.0”
| Length: 34.0”
Width: 24.0”
Height: 14.0”
| Length: 38.0”
Width: 23.5”
Height: 14.0
| Length: 36.0”
Width: 23.5”
Height: 13.0”
| Length: 30.0”
Width: 26.0”
Height: 13.0”
Weight (Excluding Battery & Accessories)| 19.0 LBS| 20.0 LBS| 22.4 LBS| 23.3
LBS| 25.1 LBS| 19.0 LBS
*Open height varies due to adjustable handle on X4, X8, X9 Series Carts
CUSTOMER SERVICE AND TECHNICAL SUPPORT
Call/text us at 888-229-5218 or email
us at support@batcaddy.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>