robern CM2444RC87 Craft Series Mirror Instruction Manual
- June 13, 2024
- robern
Table of Contents
robern CM2444RC87 Craft Series Mirror Instruction Manual
Industrial Metal
Thin Frame Metal
Round Corner Metal
GENERAL INFORMATION
This instruction sheet contains information on how to install the Craft Series Mirror. This series comes in many sizes and styles.
Please refer to the box or product label for the specific model number.
Save these instructions for future use and reference. An improper installation voids the warranty. Carefully inspect the mirror for damage. Installed products cannot be returned.
If you experience any problems with your wall mirror, contact your dealer or Robern directly.
Limited Warranty — One Year Term
TOOLS NEEDED
PARTS
Mirror
[216-1166] Mounting Hardware Bag
-
(5) Wall Anchor
-
(5) Screw
-
(2) Cleat
NOTES
- Unpack the mirror. Check the box thoroughly for all hardware and loose parts. Carefully inspect the mirror for damage.
- This mirror is for indoor use only.
- This installation may require more than one person.
PREP THE WALL
- The mounting locations for the cleats are determined by the frame’s orientation. Use the image below for the mounting location for both of the cleats. The landscape width measurements are the same for all sizes from the center line of the mirror.
- Level and mark the holes that determine the location of both cleats.
- Mirror can be mounted both in portrait and landscape orientation(see dimensions below)
- Locate the studs and drill four holes using a 3/32″ drill bit.
- If no stud is available, drill a 1/4″ hole for each wall anchor and use the supplied wall anchors*.
- Use four screws provided to attach cleats to the wall.
- Tighten screws until tight. When anchors are used, keep turning screw at least 4 more times as shown.
*Actual wall anchor many differ from type shown.
MIRROR INSTALLATION
- Hang the mirror on the cleats and check level, adjust horizontally to desired location (This may require two people).
USE AND MAINTENANCE
Use only a damp cloth to clean. Ammonia or vinegar-based cleaners can damage mirrors.
A 50/50 solution of water and isopropyl alcohol is recommended for cleaning the mirrors.
When cleaning, spray the cloth, not the mirror or surround surfaces. Do not
use abrasive cleansers on any part of the mirror
WARRANTY
Limited Warranty One Year Term
Robern warrants to the original purchaser that, it will, at its election repair, replace, or make appropriate adjustment to products made by this company shown to have significant defects in material or workmanship which are reported to Robern in writing within one (1) year from the date of delivery. Robern is not responsible for installation costs. The warranty is void in the event the product is damaged in transit, or if damage or failure is caused by abuse, misuse, abnormal usage, faulty installation, damage in an accident, improper maintenance, or any repairs other than those authorized by Robern. At the expiration of the one year warranty period, Robern shall be under no further obligation under any warranty, expressed or implied, including the implied warranty of merchantability. Robern shall not be liable for any consequential damages arising out of or in connection with the use or performance of its products. Some states do not allow limitations on how long an implied warranty lasts or do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Any liability against Robern under any implied warranty, including the warranty of merchantability, is expressly limited to the terms of this warranty. Permission to return any merchandise under this warranty must be authorized by Robern and returned prepaid by the purchaser. Claims under this warranty should be sent directly to your dealer.
©2022 Robern, Inc.
All rights reserved
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376 www.robern.com
Part no. 209-1440 04/13/2022
Craft Series Mirror
