SZYET YETSC3604A-4K Wireless Remote Control Instruction Manual
- June 13, 2024
- SZYET
Table of Contents
SZYET YETSC3604A-4K Wireless Remote Control
Product Information
- Product Name: Remote Control
- Manufacturer: SHENZHEN YAOERTAI TECHNOLOGY DEVELOPMENT CO., LTD
- Website: http://www.szyet.com
- Contact: 0755-89509951, 89509953
- Model: (YET)SC3604A-4K
- Description: This remote control is powered by a CR1233V battery and encoded by the EV1527 chip. It utilizes OOK modulation to produce a 315M wireless signal, which is then radiated by the RF-integrated chip CMT2110 and a 3DBI gain antenna.
Technical Specifications
- Operating Voltage: DC3V
- Static Working Current: 0UA
- Operating Temperature: -20°C to +80°C
- Firing Range: More than 60 meters
- Transmission Frequency: 315MHz
- Buttons: Two buttons (K1 and K2)
Product Usage
This remote control is primarily used for wireless remote control of electronic products such as cars, access control systems, and more.
Figure A : Wiring
- DC +3V – Connect to the positive terminal of the power source
- GND – Connect to the ground or negative terminal of the power source
- Add ANT – Connect to the antenna for optimal signal transmission
FCC Warning
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Output mode of remote control
the user presses the key, the K1 K2 chip recognizes the key and sends out the corresponding coded modulation signal, the 315M wireless signal is produced by OOK modulation, and then radiated by RF integrated chip CMT2110 and 3DBI gain antenna. Wiring as shown in Figure A:
Main technical indicators
- Operating voltage：DC3V
- Static working current：≤0UA
- Operating temperature：-20℃ – +80℃
- Firing Range：More than 60 meters
- Transmission frequency：315MHz
- Press the button outside the remote control：Two buttons
- K1 and K2 are two coding buttons, and only when these two buttons are pressed will the remote control emit an RF signal;
- Product Usage: Electronic products mainly used for wireless remote control, such as cars, access control, etc
Wiring diagram
FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution:
Any changes or modifications to this device not explicitly approved by the
manufacturer could void your authority to operate this equipment. This device
complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that
may cause undesired operation. The device has been evaluated to meet the
general RF exposure requirement. The device can be used in portable exposure
conditions without restriction.
SHENZHEN YAOERTAI TECHNOLOGY DEVELOPMENT CO.,LTD
http://www.szyet.com 0755-89509951 89509953
References
- rf remote control supplier,garage door remote control and wireless controller manufacturer | Shenzhen Yaoertai
- rf remote control supplier,garage door remote control and wireless controller manufacturer | Shenzhen Yaoertai
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>