EPV AT8 ISF EFinity Screens Instruction Manual
- June 13, 2024
- EPV
Table of Contents
EPV AT8 ISF EFinity Screens
Product Information
The Fixed Frame Screen is a high-quality screen that provides a dynamic and static color display. It features PWM grade brightness control and a demo mode for showcasing different modes and colors. The screen offers 18 modes, 16 colors, 256 brightness grades, and 16 grades of output color. It operates at a voltage of DC 12-24V and has a remote distance of up to 15 feet.
Product Usage Instructions
-
LED Light Assembly:
-
- Peel off the adhesive on the back of the LED light strip.
- Slowly and smoothly stick the LED light strip on the back of the frame, continuing along the entire frame.
- Secure the LED light strip using the provided LED clip.
-
Power Connection:
-
- Plug the Power Cord into the Power Supply.
- Connect the LED Controller to the Power Supply.
- Install the controller cover on the frame, ensuring that the receiver is exposed below the frame.
-
Remote Control Operation:
Use the Remote Control to perform the following actions: -
- Turns the LED lights on/off
- Increases/decreases the brightness of the LED lights
- Selects corresponding static color
- Performs color sequences (3 color step sequence, 7 color step sequence)
- Performs color fades (3 color fade change, 7 color fade change)
- Activates sound-control modes that change colors following music/sound rhythm
-
Disclaimer:
For Technical Support or to contact Elite Prime Vision in your area, visit www.epvscreens.com
SPECIFICATION
| Dynamic Mode | 18 modes | Direct Color Select | Yes |
|---|---|---|---|
| Static Color | 16 colors | Output Color Switchable | Yes, 10 options |
| PWM Grade | 256 grades | Operating Voltage | DC 12-24V |
| Brightness Grade | 16 grades | Output Current | 3x4A peak, 3x2A constant |
| Demo Mode | Yes | Remote distance | Up to 15 feet |
Hardware Parts List
LED Light Assembly
-
Step 1. Peel off the back to expose the adhesive.
-
Step 2. Stick the LED light strip on the back of the frame slowly and smoothly. Continue all along the entire frame.
Note: If the LED strip is too long, it can be cut between the RGB contact points as shown below.
-
Step 3. Secure the LED light strip by using the LED clip as shown below.
-
Step 4. Plug the Power Cord to the Power Supply
-
Step 5. Connect the LED Controller to the Power Supply
-
Step 6. Install the controller cover on the frame.
-
Step 7. Remote Control Operation
Disclaimer (Warning)
Please be cautious when handling and installing the LED light kit as the
sensors are delicate. Avoid any actions that may damage the kit such as
bending, stretching, ripping, or stepping on the lights as any damage that
occurs with such activities will void the warranty. The LED kit was designed
for the sole purpose of being installed onto the back of the Polar star
eFinity frame. Do not use the LED kit for alternative purposes such as, but
not limited to; decorative purposes, a primary source of light, installation
on other appliances, etc. Any damage that may occur from improper
installations will not be covered under the warranty policy.
For Technical Support or an Elite Prime Vision contact in your area, visit
www.epvscreens.com
References
- Homepage - EPV Screens® Projection Screens for The Custom Installation
- Homepage - EPV Screens® Projection Screens for The Custom Installation
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>