Impress IM-12B Basic Clothing Iron User Manual

Impress IM-12B Basic Clothing Iron

IMPORTANT SAFEGUARDS

SAFETY
This symbol identifies hazards that may cause injuries.

INTENDED USE

• This appliance is intended for ironing textiles for private use only. It is not suitable for commercial use. only use this appliance for its intended use as described in this instruction manual.
• In order to avoid any risks or hazards possibly involved in the use of electric appliances, closely follow the below safety instructions.

GENERAl SAFETY INSTRUCTIONS

• The manufacturer takes no responsibility for any damage caused by incorrect use.
• Incorrect or improper use can damage the appliance and cause injuries to the user.
• Before connecting this appliance to the mains, make sure your local voltage matches the technical data of the appliance. otherwise, the appliance may overheat and get damaged.
• caution! danger of electric shock!
• never put the appliance, cord or plug into water or any other liquid.
• do not use the appliance near a sink or wash basin.
• do not use the appliance with wet hands.
• do not use the appliance outdoors.
• an electric appliance is not a toy!
• never leave the appliance unattended during use.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• children should be supervised to ensure that they do not play with the appliance.
• always unplug your appliance when it is not in use, and before cleaning.
• always pull the plug – not the cord.
• Keep the appliance and the cord well away from any hot surfaces to avoid any damage to the appliance.
• Make sure the cord may not inadvertently be pulled or cause anyone to trip when in use. do not allow the cord to hang over sharp edges.
• do not bend the cord or wind it around the appliance.
• do not use the appliance,
• if the cord is damaged.
• in case of malfunction.
• if the appliance was dropped or is damaged otherwise. have it checked and, if necessary, repaired by a qualified person. never attempt to make any modifications to or repair the appliance yourself.
• only use accessories evaluated for use with this appliance.
• never attempt to drive any objects into the appliance.
• never attempt to open the housing yourself!

WARNING

POLARIZED
This appliance has a polarized plug (one blade is wider than the other.) as a safety feature, this plug fits in a polarized outlet only one way. If the plug does not fit into the outlet, reverse the plug and try again. If it still does not fit, contact a qualified electrician. do not attempt to defeat this safety feature.

ELECTRICAL CORD

The cord of this appliance was selected to reduce the possibility of tangling in or tripping over a longer cord. longer power-supply cords or extension cords are available and may be used if care is exercised in their use. If an extension cord is used: (1) the marked electrical rating of the extension cord should be at least as great as the electrical rating of the product; (2) the extension cord should be arranged so that it will not drape over the countertop or tabletop where it can unintentionally be pulled on or tripped over by children or pets.

PARTS

1.  Spray nozzle
2.  Water inlet
3.  Steam control
4.  SteamBurst button (IM-14G only)
5.  Spray button
6.  Temperature pilot light
7.  Swivelling cord protector
8.  Power cable
9.  Water tank
10.  Temperature control
11.  Soleplate
12.  Water measuring cup

INSTRUCTIONS

• The iron must be used and rested on a stable surface. only fill in water, no other liquids or additives!
• high temperatures develop at the soleplate (11) of the steam iron which can cause serious burns. Therefore, always take the appliance by its handle and warn others (especially children) against possible hazards (e.g. scalding from steam or hot water).
• never put the iron down on its soleplate (11) during use. when placing the iron on its stand, ensure that the surface on which the stand is placed is stable.
• always disconnect the power cable
  • Before filling the water tank (9) or emptying it.
  • when leaving the iron unattended (even for a short time).
  • Before cleaning.
  • Immediately after use.
• do not use the iron when it leaks
• WARNING! Never iron clothes on the body!

BEFORE FIRST USE

• If necessary, peal the protective foil off the soleplate (11). Wipe the soleplate with a soft cloth

OPERATION

FILLING THE WATER TANk
Warning! Before filling the tank make sure the iron is not plugged into the outlet. Always disconnect the power plug prior to filling. using distilled or purified water only. you can use tap water, but more frequent cleaning is advised.

• Set the steam control (4) to – (steam off).
• open the water inlet (2).
• Fill in water (no additives) up to the maximum filling mark indicated on the water tank (9).
• close the water inlet (2) again.

Please note : To prevent corrosion and spilling, we recommend emptying the water tank (9) after use

CONNECTING TO POWER

•  connect the power plug of the appliance to a properly installed and easily accessible wall socket. The temperature pilot light (6) lights up while the iron heats up. It goes out as soon as the iron reaches the preset temperature. you may now start ironing.
•  during ironing, the temperature pilot light (6) automatically cycles on and off as the iron heats up and cools down.

SETTING THE IRONING TEMPERATURE
Set the temperature control (10) according to the international textile protection symbols (located on the temperature control (10) and the washing label of the garment).

• rayon, acrylic (low temperature)
• Silk, wool (medium temperature)
• cotton, linen (high temperature)
• Pre-sort the garments if necessary.

STEAM IRONING
The quantity of steam is regulated by the steam control (3). – Move the steam control (3) to a position between minimum and maximum depending on the quantity of steam required and the temperature selected. warning: the iron gives off steam continuously only if you hold the iron horizontally. you can stop the continuous steam by placing the iron in a vertical position or by moving the steam control to the “Max” position as the arrow. You can only use steam at the highest temperatures. If the selected temperature is too low, water may drip onto the plate.

SPRAY
use the spray function to iron out stubborn creases at any temperature. Simply press the spray button (5), when required. Make sure there is enough water in the water tank (9).

STEAMBURST (MOdEl IM-14G ONly)
Press the SteamBurst button (4) to generate a powerful burst of steam that can penetrate the fabrics and smooth the most difficult and tough creases. If bursts become weak, wait a few seconds until the unit cycles through and replenishes steam capacity.

Dry Ironing
For dry ironing, set the steam control (3) to – (steam off). If you put down the iron in an upright position, steam production stops as well.

SElf-ClEANING

Regularly clean the steam iron depending on the frequency of use and the local water quality. In case of rather hard water self-cleaning is recommended at least every 2 weeks.

•  Set the steam control (3) to – (steam off).
•  Set the temperature control (10) to the highest level.
•  open the water inlet (2) and fill the water up to the maximum filling mark in the water tank (9). close the water inlet (2).
•  connect the power plug of the iron to the wall socket.
•  let the iron heat up until the temperature pilot light (6) goes out.
•  disconnect the power plug.
•  hold the iron horizontally across a sink.
•  Set the steam control (3) to self-clean then pull out the steam control(3). Boiling hot water and steam come out of the soleplate (11) washing out any lime scale. Sway the iron to and fro during this.
•  Set back the steam control (3) to – (steam off).
•  wipe the soleplate (11) on a (preferably) old piece of cloth. connect the power plug to the wall socket again and let it heat up. any residual water now evaporates through the soleplate (11).
•  unplug the appliance and let it cool down before stowing it away.

STORAGE

• after use, unplug the iron and let it cool down.
• Set the temperature control (10) to the lowest level.
• empty the water tank (9).
• Set the steam control (4) to -(steam off) .
• If necessary, wipe the iron with a soft damp cloth.
• Store the iron out of the reach of children and in a clean and dry place.

Useful AdVICE

• when the iron is used for the first time, some smoke may be generated. This is due to cardboard dust and is quite normal and stops shortly after having started ironing.
• damp clothes are easier to iron than fully dry clothes.
• when using spray starch we recommend wiping the soleplate (11) from time to time to avoid the build-up of any residues.

TECHNICAl dATA

• Voltage 127 V ~ 60 hz
• output 1200 w

Warranty

Length of Warranty

• 1 year from the date of purchase
• Within 1 year from the date of purchase,
• Return the product to the place of purchase (if your dealer allows it)
• Send product postage pre-paid to:
  • I.E.A.C.
  • 3030 E. Vernon Ave.
  • Vernon, CA 90058

Please include the original dated receipt, an explanation of the defect, and return name and address as well as a contact phone number. We will, within 10 days of receiving your product, return a new or refurbished (at our discretion) product at NO ADDITIONAL CHARGE. We will also return your receipt. If the product is found to be in working condition, we will return the product postage collection.

PACK YOUR PRODUCT WELL!
We will not be responsible for damages incurred as a result of improper packing.

Or contact us via e-mail at customerservice@betterchefimpress.com

FAQs

What is the power rating of the Impress IM-12B Basic Clothing Iron?

The Impress IM-12B Basic Clothing Iron typically has a power rating of 1200 watts, providing efficient and effective ironing.

Is the iron suitable for both dry and steam ironing?

Yes, the Impress IM-12B Basic Clothing Iron can be used for both dry and steam ironing, offering versatility in your ironing tasks.

Does it have adjustable temperature settings?

Yes, the iron usually features adjustable temperature control, allowing you to select the appropriate heat level for different fabrics.

What type of soleplate does it have?

The Impress IM-12B Basic Clothing Iron typically comes with a non-stick soleplate, making it easy to glide over fabrics without sticking or snagging.

Is there a water reservoir for steam ironing?

Yes, the iron usually includes a water reservoir for steam ironing, which can be filled to produce steam for wrinkle removal.

What safety features does the iron have?

Common safety features may include an auto-shutoff function when the iron is left unattended and an indicator light to show when it's hot.

Can the iron be used vertically for steaming clothes on hangers?

Yes, the Impress IM-12B Basic Clothing Iron can be used vertically for steaming hanging clothes or drapes.

What is the length of the power cord?

The power cord of the iron is typically around 15 feet, providing flexibility in your ironing setup.

Is it suitable for international use with different voltage requirements?

Some models may offer dual voltage compatibility, but it's essential to check the specific product details for international use.

How do I clean the soleplate of the iron?

To clean the soleplate, you can use a damp cloth or a soleplate cleaner, following the manufacturer's instructions for maintenance.

Can distilled water be used in the iron's water reservoir?

Yes, using distilled water is recommended to prevent mineral buildup in the iron's steam system.

What is the warranty period for the Impress IM-12B Basic Clothing Iron?

The warranty period may vary by manufacturer, so it's advisable to check the product's warranty information for specific details.

Download This PDF Link:Impress IM-12B Basic Clothing Iron User Manual

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>