Xinjiawei Technology WC-008 Mag-Modular 3 In 1 Wireless Charger User Manual
- June 12, 2024
- Xinjiawei Technology
Table of Contents
Mag-Modular 3in1 wireless charging
Model No:.WC-008
Instruction
Size:65.57575mm
N.W: 368g
| Power Input: | DC 5V/2A 9V/2A 12V1.67A 20W |
|---|---|
| Output: | 2.5W/5W/7.5W/10W/15W |
| Connector | USB-C |
| Charging Distance | <8MM |
| Conversion efficiency: | 70% |
| LED Light | Mobile Phone: Green/Earphone: Blue/Watch: White Full |
Charging/FOD/Over voltage, under voltage and over temperature protection :
Red
Required Charger| AC Charger USB-C PD25W
Please user only included cable for charging pad
Exposure to Radio Frequency Energy
The radiated output power of the wireless charger meets applicable radio frequency exposure limits. The wireless charger should be operated with a minimum separation distances of 20cm(8 inches) between the MagSafe wireless charger, or any devices on the wireless charger, and a person’s body.
Warning
When using the wireless charger, remove metallic cases and avold placing
metallic foreign objects in it (for example, keys, coins, batteries, or
jewellery), as they may interfere with charging or become warm enough to cause
discomfort or injury lf yoursk in comes into contact with them.
Don’t place any item with an RFID tag (for example, a contactless credit card,
passport, or access card) on the MagSafe wireless charger, because the RFID
tag could be damaged.
IMPORTANT NOTICE
In order to guarantee the proper functioning of the product and its charging potential, a 25W USB-C mains charger (not supplied) is required. The use of a charger with different specifications could degrade the product, your device or not provide the adequate power for its proper functioning.
FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’ s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>