velleman WSSA122 LED Animated Bell Soldering Kit Instruction Manual
- June 12, 2024
- Velleman
Table of Contents
velleman WSSA122 LED Animated Bell Soldering Kit
Product Information
- Product Model: WSAA122-16022021
- Power: Maximum 40W
Components:
- R1… R4: 0 Ohm (Black) – (zwart) – (noir) – (Schwarz) – (Svart) – (Musta) – (Negro) – (Preto)
- R5… R17: 1K (Brown, Black, Red) – (Bruin, Zwart, Rood) – (Brun, Noir, Rouge) – (Braun, Svart, Musta, Negro, Preto)
- R18, R19: 3K3 (Yellow, Orange, Orange, Red) – (Geel, Oranje, Oranje, Rood) – (Jaune, Naranjado, Naranjado, Rojo) – (Gelb, Laranja, Laranja, Encarnado)
- R20… R28: 1K8 R29, R30: 100K
- SW1: Watch the polarity!
- T1, T2: BC547
- C1, C2: Electrolytic Capacitors
Other Components
- 6 POWER JACK
- START
- BATTERY HOLDER
- SWITCH
- TRANSISTOR
- LED
Schematic Diagram: (Diagram not provided in the text)
Important Environmental Information:
This product contains a symbol indicating that it should not be disposed of
as unsorted municipal waste. It should be disposed of through a specialized
recycling company or returned to the distributor or a local recycling service
in accordance with local environmental rules and regulations.
TO ALL RESIDENTS OF THE EUROPEAN UNION
Important environmental information about this product This symbol on this
unit or the package, indicates that disposal of this unit after its lifecycle
could harm the environment. Do not dispose the unit as unsorted municipal
waste; it should be disposed by a specialized company for recycling. This unit
should be returned to your distributor or to a local recycling service.
Respect the local environmental rules. If any doubt contact your local
authorities about waste disposal rules.
Product Usage Instructions
- Connect the 6 POWER JACK to a power source with a maximum rating of 40W.
- Turn on the SWITCH (SW1).
- Follow the schematic diagram to connect the various components (R1… R30, T1, T2, C1, C2) according to their color codes and values.
- Ensure that the polarity of the components, especially the Electrolytic Capacitors (C1, C2), is correctly observed.
- Insert a 9V BATTERY into the BATTERY HOLDER.
- Observe the LED for any indication or response.
Note: For detailed instructions on component connections and circuit configurations, refer to the provided schematic diagram.
Soldering
START
Resistor
SWITCH
TRANSISTOR
ELECTROLYTIC CAPACITORS
LED
POWER JACK
BATTERY HOLDER
SCHEMATIC DIAGRAM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>