Show Lights AL28 Super Projector 7 Light Effects Instruction Manual
- June 10, 2024
- Show Lights
Table of Contents
Show Lights AL28 Super Projector 7 Light Effects
SUPER PROJECTOR INSTRUCTION MANUAL
PACKAGE CONTENTS
Specification
- Input: 120V~ 60Hz,
- Output: 12V, 1 A
- Lights: Red/Green/Blue Led
- Operation: indoor/outdoor
- Remote Control: x1
- Operating Temperature: -15°F to 90°F (-26°C to 32°C)
- Dim.: 7.5 in 6 in 17.5 in
- Projection Coverage: 60Ft * 60Ft
- Warranty: One Year Limited
INSTALLATION
- Screw the stake into the holder to secure the projector. Or screw the base to secure the projector.
- Connect Adapter as the figure shows.
PRODUCT DESCRIPTION
- Bui it-in timer function: 6hrs on, 18hrs off.
- Press the button to switch light modes.
- Press and hold the button 2s to turn off the lights.
Button Function
- Press and hold the button for more than 2 seconds to turn it off.
- Press the button to switch 7 different light modes. Modes as below:
- Red lights sparking
- Green lights sparking
- Red and Green sparking
- Blue lights sparking
- Red and blue sparking
- Green and Blue sparking
- RGB sparking
- Memory Function: Power off, when short-pressing the button to turn on, the projector will stay at the last mode.
REMOTE CONTROL
- Remove the insulating tape from the battery compartment before use.
- Remote Control description.
Battery installation
If the Remote Control does not work, check the batteries.
- slide the battery cover off.
- Insert Battery AAA*2pcs.
WARNING: This is not a toy and is not intended for use by children.
- (A). Do not dispose of the battery in fire as the battery may leak and explore.
- (B). Do not mix old and new batteries and not mix alkaline, standard(carbon-zinc), or rechargeable (nickel-cadmium) batteries.
- (C). Exhausted batteries are to be removed from the product.
- (D). Dispose of the battery properly by following directions on the battery.
- (E). Use AAA batteries only. The use of other batteries may damage the remote control.
- (F). Safe for indoor use.
- (G). Do not expose the Remote Control to moisture.
CAUTION
- Do not place products near any heat source such as radiators, stoves, fireplaces, etc.
- Do not use in a bathroom.
- Do not secure the wiring of the product with staples or nails or place on sharp hooks or nails.
- Do not close doors or windows on the product or product cord as this may damage the wire insulation.
- Do not cover the product with cloth, paper or any material not part of the product when in use.
- Do not operate the unit with a damaged plug.
- Do not operate the unit if it has been subjected to damage in any way.
WARNING
- Always ensure the light set is unplugged when installed.
- This is an electric product-not a toy! To avoid the risk of fire, burns, personal injury, and electric shock it should not be played with or placed where small children can reach it.
- Do not use this product for other than its intended use.
- Do not disassemble the adaptor. Disassembly may result in a risk of electric shock or fire.
FCC STATEMENT
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any Changes or
modifications not expressly approved by the party responsible for compliance
could void the users’ authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>