PROTECHT SCC001NA Single Charging Case User Manual
- June 10, 2024
- PROTECHT
Table of Contents
PROTECHT SCC001NA Single Charging Case
FCC ID: 2AT9A-SCC001
ELECTRICAL SAFETY INFORMATION
Operating Conditions: Single Charging Case
- External Operating Temperature: -10 to +30C
- Input Power (DC supply): 5V 1A
This system complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
- This device may not cause harmful interference
- This device must accept any interference received including interference that may cause undesired operation.
Product Usage Instructions
- Line the charging coil on the mouthguard to the charging coil on the side of the case.
- Use the adjustable arms to secure the mouthguard against the charging coil.
- The position of the arms can be adjusted if needed by loosening the screw.
- The arms should push the mouthguard as close to the coil as possible.
- Ensure that the red light stays on, indicating that the mouthguard is being charged properly.
ELECTRICAL SAFETY INFORMATION
Operating Conditions: Single Charging Case
- External Operating Temperature: -10 to +30C
- Input Power (DC supply): 5V 1A
This system complies with Part 15 of the FCC rules. Operation is subject to the following conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received including interference that may cause undesired operation.
No changes shall be made to the equipment without the manufacturer’s permission as this may void the user’s authority to operate the equipment.
This equipment should be used with a minimum distance of 20cm between the device and users and meets the mobile RF exposure requirements of 47 CFR part 2.1091 and part 1.1307.
Charging and Sleep mode
The PROTECHT Version 2 mouthguard requires around 4 hours of charge to full
voltage (around 4.2V). The guard will last for around 4 hours while the
processor is on. The Mouthguard has a sleep mode function where after 10
minutes it will switch off should no major movements have been detected on the
mouthguard. The mouthguard requires a few impacts to ‘wake up’. When
connecting the mouthguard to Bluetooth prior to a session in order to activate
the internal clock it is possible to disable the sleep function for a set time
using the associated mimic app.
In order to charge the guard successfully the mouthguard charging coil needs
to be positioned over the circular charging board as shown below. For optimal
charging, it is very important that the coils are aligned in parallel. It is
also important that the mouthguard is fixed as close to the charging coil as
possible. The charging case can be personalised to fix the individual
mouthguard in place using adjustable arms. Successful charging is taking place
when a red light is emitted from the LED as shown. The green Light on the side
of the charging case will continually flash green while the mouthguard is
connected on charge.
Line charging coil on the mouthguard to the charging coil on side of case
Uses
adjustable arms to secure the mouthguard against the charging coil. The
position of arms can be adjusted if needed by loosening the screw. Arms should
push the mouthguard as close to the coil as possible. 
Ensure red light stays on,
this indicates the mouthguard is being charged properly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>