wampat LIGHTING EREBUS Series Table Lamp Installation Guide
- June 9, 2024
- wampat LIGHTING
Table of Contents
wampat LIGHTING EREBUS Series Table Lamp
WHAT’S IN THE BOX
Tools Required（Not Included）
Erebus series
WAMPAT LIGHTING pursues the essence of life, from the light source to the
product, and to the environment where the product is located. We express the
essence and unity of life, and let the light source integrate into life.Thank
you for choosing our products please read the instructions carefully before
installation,and please keep the instructions properly
Assembly
CAUTION
- Read instruction carefully and turn electricity off at main circuit breaker panel before beginning installation.
- Electrician installation highly recommended. All glass is fragile Use care when handling glass component(s) and or lamp(s).
- Read instructions carefully and turn electricity off at the circuit breaker panel before beginning installation
Warning:
- if any special control devices are used with this fixture. Follow the instructions carefully to assure full compliance with N.E.C requirements If there are any questions, Contact a qualified electric contractor.
- California Residents Proposition 65 This product contains lead A chemical know to the state of California to cause cancer and birth defects or other reproductive harm. Do not place the product in your mouth. Wash your hands after handling this product
- Before you start. Never attempt any work without shutting off the electricity until the work is done.Go to the main fuse, or circuit breaker. box in your home, place the main power switch in the “OFF” position.
INSTALL
Step 1
Assemble lampshade: Take out the shade metal frames (D). (E) and fabric
plece (F) and lamp body (A).(B). (C) from box. Fit the fabric plece (F) on the
metal frames (D)(E) with their own hook and loop fasteners as a diagram to get
a completed lampshade..
STEP 2
- Pull the remaining cable (C)out of base.
- Fbx the socket (B) on the base (A) by turning it in clockwise direction until it tightened.
- Put the fabric shade (G) on the socket (B) and lock it by ring.
- Screw the bulb (E26 Max 60W.(not included))
STEP 3
Connect the plug into an outlet and twist the rotary switch on the socket to
turn on the light.
TIPS AND TRICKS
- Do not attempt to move this furniture without first removing all equipment
- Death or serious injury may occur when children climb on audio and/or video equipment furniture. A remote control or toys placed on the furnishing may encourage a child to climb on the furnishing and as a result, the furnishing may tip over onto the child.
- Please contact us using the details shown for further advice