HiFiAudio Vera-Fi Audio Vibration Black Hole User Guide
- September 26, 2024
- HiFiAudio
Table of Contents
Vera-Fi Audio Vibration Black Hole
“`html
Product Information
Specifications:
- Brand: Vera-Fi Audio, LLC
- Model: VBH-1
- Components Included: Install Tool x4, VBH Base x4, Double Sided
Adhesive x4, Spike Feet x4
Product Usage Instructions
- Unpacking and Setup:
1. Unpack and verify all components. Choose a flat and solid
surface for the VBH-1.
- Mounting Spikes:
2. Identify the location to mount the spikes on your equipment
ensuring an even surface. Attach the double sided adhesive dots to
the bottom of the spikes.
- Attaching VBH Feet:
3. Remove the equipment to be isolated, position the VBH feet
under the equipment, and place the spikes in the center of their
bases using the plastic holders to keep them upright.
FAQ
Q: Can I use VBH-1 with all types of electronic equipment?
A: VBH-1 is designed for use with a variety of electronic
equipment. However, ensure that the weight and size of your
equipment are compatible with VBH-1 for optimal performance.
Q: Is it necessary to use all four spike feet included in the
package?
A: To achieve balanced support and isolation, it is recommended
to use all four spike feet provided with the VBH-1.
“`
Measured impact on turntable without VBH Measured impact on turntable with VBH
Quick Start Guide
Vibration Black Hole
Vera-Fi Audio, LLC
Copyright 2023 by Vera-Fi Audio, LLC. All rights reserved.
– 4 –
Vera-Fi Audio, LLC www.verafiaudiollc.com (818) 584 – 6870
– 1 –
What’s Included:
Install Tool x4
VBH Base x4
Double Sided Adhesive
x4
Spike Feet x4
Instructions for Use:
Thank you for your purchase of VBH-1! For best performance and mechanical
isolation, please follow these instructions. Set-up is easiest and safest with
assistance especially with heavy or sensitive electronics.
1. Unpack and verify all components. Consider where you plan
to use VBH, ensuring a flat and solid surface.
– 2-
2. Locate where you will mount the included spikes to the bottom of your
equipment. This should be a clean and flat surface that is even on all 4 sides
of the component where weight will be evenly distributed. In some cases the
spikes can be attached to the bottom of the stock feet. Be sure that your
equipment is off and disconnected for safety.
3. Attach the double sided adhesive dots to the
bottom of the included spikes. Do not take off the second adhesive cover until
ready to attach the spikes. This smooth surface will protect your equipment
while experimenting with spike placement.
4. Remove the component you wish to
isolate and place the VBH feet where they will be supporting the equipment.
Nestle the four spikes in the center of their respective bases and use the
included plastic holders to keep the spikes in the upright position. The
holders do not lock and are connected on one side by tape that can be removed
if more convenient.
5. Once all four spikes are installed and set into the bases, remove the pads
from the adhesive and carefully lower your component onto the four spikes.
Test the component for stability. It should not rock and should be securely
suspended by VBH-1. Use a pen or other long object to open and remove the
installation tools. Your device should now be mechanically isolated by our
unique CVLD system, absorbing vibration and impact energy. Reconnect your
component(s) to your stereo system and enjoy the music!
– 3 –
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>