artika VAN4RA-RN Ratio 4 Wall Mounted Light Fixture Instruction Manual

June 6, 2024
artika

artika logo VAN4RA-RN Ratio 4 Wall Mounted Light Fixture
Instruction Manual

artika VAN4RA RN Ratio 4 Wall Mounted Light Fixture

INSTRUCTION MANUAL
IMPORTANT, KEEP FOR FUTURE REFERENCE: PLEASE READ CAREFULLY.

intertack icon
Made in China
Residential use only
Indoor use only

INCLUDED HARDWARE

ITEM DESCRIPTION QUANTITY
Wire connector × 3
Junction box screw × 2
Retaining screw × 2
Wall anchor × 2
Decorative nut × 2
Mounting bracket and base × 1

WHAT YOU WILL NEED…

artika VAN4RA RN Ratio 4 Wall Mounted Light Fixture -WHAT YOU WILL
NEED

CAUTION
If using a dimmer, it must be LED compatible.
IMPORTANT
The installer and/or user must read, understand and follow these instructions before installing the product. This product must be properly installed before it is used.
If instructions are not followed, the manufacturer will not be held responsible for any problems or product malfunction. Failure to follow installation and/or operating instructions voids the warranty.
We recommend that this product be installed by a certifi ed electrician. In some states or provinces, it is a legal requirement for this type of product to be installed by a certifi ed electrician, according to the electrical and building codes effective in the region where the unit is used.
Switch off the main electrical supply from the fuse box/circuit breaker before installing the unit or doing any maintenance.

STEP-BY-STEP
INSTALLATION

  1. Turn off the breaker at the panel.

  2. Place the mounting bracket over the junction box and verify the position with the level. Mark on the wall the two locations at the end of the mounting bracket where the holes will be drilled.

  3. Drill two pilot holes in the wall. Push the wall anchors into the holes.

  4. Attach the mounting bracket to the junction box fastening it with the junction box screws.

  5. Screw the retaining screws into the wall anchors (fi g. 1).
    artika VAN4RA RN Ratio 4 Wall Mounted Light Fixture -fi g
1

  6. Attach the hook to the mounting bracket (fi g. 2).

  7. Connect the white wire (N) from the light fixture to the white supply wire (N) from the junction box using a wire connector. Connect the black wire (L) from the light fixture to the black supply wire (L) from the junction box using a wire connector. Connect the ground wire (G) from the light fixture to the ground supply wire (G) from the junction box using a wire connector (fi g. 2).
    artika VAN4RA RN Ratio 4 Wall Mounted Light Fixture -fi g
2

  8. Push the wires into the junction box. Mount the light fixture onto the mounting bracket and secure it with the two decorative nuts (fi g. 3).

artika VAN4RA RN Ratio 4 Wall Mounted Light Fixture - fi g
3

WARRANTY

Artika For Living Inc. is proud to offer you a one (1) year limited warranty on manufacturing defects from the date of purchase for residential use only. The warranty is extended to the original owner in USA and Canada and is non-transferable. It does not apply to retailers, commercial applications or establishments. The original sales receipt is
required for all warranty claims. The remedy under this limited warranty shall be a product or part replacement at Artika’s discretion as provided herein and cannot exceed the original purchase price.
This warranty is valid only on products installed in accordance with the building code and laws effective in the region where the unit is used as well as in accordance with the provided instruction manual. It does not cover products installed incorrectly or subjected to abnormal use. Product(s) or component part(s) may be required to be returned for inspection and verification.
Normal wear and tear, misuse, negligence, vandalism, improper maintenance (surface damage due to chemical interaction or cleaning agents including, but not limited to, scouring pads, use of cleaners containing abrasives, alcohol, or other organic solvents) improper handling, accident, abuse, fi re, flood, theft, acts of God, neglect, or alteration of the product will not be covered under this limited warranty. It excludes any accessories that accompany the product including but not limited to bulbs or batteries.
The warranty does not cover handling, labor, transportation, or any other cost associated with the installation or replacement of the product. This limited warranty is valid in the country of purchase and by Artika authorized retailers only.
Artika for Living Inc. will not be held responsible for any direct or consequential damages or injuries related to the use of this product arising from improper use or installation of this product. Please visit www.artika.com to discover more about Artika for Living Inc.

WARNING:
Changes or modifi cations to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received,including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

GLASS DIFFUSER
INSTALLATION

  1. Screw the diffusers onto each of the receivers. Make sure that it is secure (fi g. 4).
  2. Restore electrical power.

artika VAN4RA RN Ratio 4 Wall Mounted Light Fixture - fi g
4

REPLACEMENT PARTS

ITEM DESCRIPTION Artika #
Glass diffuser VAN4RA / P1

Operation is subject to the following two conditions:

  1. this device may not cause interference, and
  2. this device must accept any inteference, including inteference that may cause undesired operation of the device.

artika logoArtika For Living Inc.
1756, 50th Avenue
Montréal (Lachine), Quebec
Canada H8T 2V5
1-866-661-9606
support@artika.com
www.artika.com
Customer service
Monday to Friday
9 a.m. – 5 p.m. EST

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals