viking TECHNOLOGY SMG840-D2 Managed Industrial Switch Installation Guide
- June 4, 2024
- viking TECHNOLOGY
Table of Contents
viking TECHNOLOGY SMG840-D2 Managed Industrial Switch
Overview
The SMG840-D2 Managed Industrial Switch supports up to 810/100/1000
Base-TX RJ45 + 4100/1000Base-X SFP ports. The PoE version (SMG840P-D2)
provides PoE (IEEE802.3af/at) as Power Sourcing Equipment (PSE) up to 30W per
port.
Package Contents
- SMG840-D2 (SMG840P-D2) Switch x 1
- This Quick Installation Guide x 1
Installation
- To install the switch on a DIN rail, lock the upper part of the DIN rail clip on the upper side of the DIN rail and then gently press it until the clip is securely locked on the rail.
- To install it on the wall – re-position the wall-mount plates, which are already screwed on the unit. Remove din-rail clip if it interferes to mount the unit on the wall.
- Connect your network devices to the RJ45 switch ports with network cables.
- Insert selected SFP modules into the SFP ports. Connect fiber cables to the SFP modules fiber ports.
- Connect your power supply (range: 9-56VDC for non-PoE, 48-52VDC for PoE model) to green terminal block to V1+ and V1- pins. If unit to be powered from two power sources, connect second power supply to V2+ and V2- pins.
- Power up your power supply(-ies) to power up the unit.
- If all cables are correctly connected, the indicators will lit as per LEDs status:
LEDs status
| LED | Color | Indication |
|---|---|---|
| PWR1 | Green | Lit when unit is powered from Power 1 input |
| PWR2 | Green | Lit when unit is powered from Power 2 input |
| RUN | Green | Blink when system is running normally |
| ALM | Red | Lit when there is an alarm in the system By default, it lits when |
unit is powered from only one power input
9-12 (SFP ports)| Green| Steady Lit when fiber link is established Blink when
data is being transmitted
1-8 (RJ45 ports)| Yellow| Steady Lit when connection is established Blink when
data is being transmitted
Green| Off when 10/100Mbps link is established Steady Lit when 1000Mbps link
is established
Web login
-
Connect the switch to your PC with a network cable
-
Set your PC’s fixed IP address to 192.168.1.2
-
In your PC’s browser enter the default switch’s IP address: 192.168.1.6
3.1. Default Username: admin
3.2. Default Password: admin -
For settings details, please check Switch’s web user manual
Contact information
Vikings Technology Co., LTD.
www.vikingstechnology.com
support@vikingstechnology.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>