Shenzhen Mofhie Wireless Charging Technology Co LTD FD1 Tab Instructions
- June 1, 2024
- Shenzhen Mofhie Wireless Charging Technology Co LTD
Table of Contents
FD1 Product Instruction
Product overview
Instructions for device operation
Power On
Locate the button, the Press the button once to turn it on.it should a
ringring chime indicating it is powered on.
Power Off
Locate the button,Press and hold the button for 3 seconds until 2 beeps are
heard.
Serical Number Lookup By BLE
Locate the button, the Press the button 2 times(2x).You will hear a
confimation sound.
Factory Reset
Locate the button,Press the function button four times rapidly and then hold
it in the fifth time until you hear a ringring chime.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in po rtable exposure condition without restriction.
FCC ID: 2BCZZ-FD1
Documents / Resources
|
Shenzhen Mofhie Wireless Charging Technology Co LTD FD1
Tab
[pdf] Instructions
FD1 Tab, FD1, Tab
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>