CARMOCAR WS-H138 Soft Roll Up Tonneau Cover Installation Guide
- June 17, 2024
- CARMOCAR
Table of Contents
CARMOCAR WS-H138 Soft Roll Up Tonneau Cover
PARTS LIST
USING INSTRUCTION
- Clean the truck bed thoroughly before installation.
- Stick the supplied front seal strip on the front bed rail by aligning it with the outer edge.
- Insert Side Rails (L&R) into the front rail of the front end. Make sure the Side Rails are parallel and all placed on the bed rails. And check that the reserved positions of Side Rails and bed Rails are the same.
- Untie the spring cords on both sides of the bed cover and unfold the bed cover to ensure correct and neat coverage of the entire lathe Snap the tail lock into the lock groove of the side rails as shown.
- Press down to close the cover and the lock will automatically clamp.
FINISH THE INSTALLATION
- Tighten the velcro on both sides of the bed cover. Make the cover more docile and overall, and finally complete the installation.
COMPLETED
Open the tailgate, pull down the rope, and the lock will automatically open.
Roll up the tarp and buckle the spring cord to enjoy plenty of bed space.
There is a scale label on the tail of the side rail. If you find that the bed cover tarp is loose, you can move the tail lock backwards according to the situation. Will make the tarp tighter.
SPECIAL INSTRUCTIONS FOR ALTERNATIVE BRACKETS SUPPLEMENT TO INSTALLATION INSTRUCTIONS (Only for models with system track)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>