PAXA PA-H01 Noise Cancelling Headphones Instruction Manual
- June 16, 2024
- PAXA
Table of Contents
PAXA PA-H01 Noise Cancelling Headphones
Product Parameters
- Bluetooth version
- Transmission distance
- Battery capacity
- Playing time
- Charging time
- Driver impedance
- Frequency response range
- Sensitivity
- Rated input
Packing Content
- V5.3
- 10m
- 400mAh 3.7V
- 30 hours
- 2 hours
- 322÷15%
- 20Hz-20KHz
- 110dB‡3dB
- 5V=== 380mA
Caution On Battery
- Risk of explosion if battery is not replaced properly
- Replace with same type of batteries only
- Self replacement of battery is prohibited
- Return to manufacturer for service
- Keep batteries away from direct sunlight, high temperature and humidity
Product Overview
- Volume Up/Next Song
- Multi Function Button (MFB)
- (Pouse Last Number Redid Up/Play/Volume Down/Previous Song
- Bluetooth Indicator
- Type-C Charging Port
- 3.5mm Audio Port
- Microphone
- ANC Button
Operating Instructions
Power On/Off
Press MFB button to turn on the headphones, ice blue indicator flashes and
voice prompt “Power On” will be heard. Press MFB button again to turn off
headphones, red indicator flashes and voice prompt “Power Off” will be heard.
Pairing
Press MFB button, turn on the Bluetooth of the smart device and search for
“PA-H01” headset to pair, click connect, when the pairing is successful, you
will hear “Connected”.
Note: The headset will automatically enter pairing mode the first time it
is used and powered on. This product has a bluetooth memory function, you only
need to turn on the headset and the device to use it again, and it will
automatically connect).
Product operating instructions
Volume Control
Turn up the volume: When the music is playing, press the.*” key for the
volume.
Phone Call
Answer/End Call: short press the MFB
Reject Call: long press the MFB about 2 seconds
Redial: quickly double press the MFB for redial the last dialed phone number
Music
A song: ng re one ” button for 2 seconds, The next song: long press 0 volume
“+” key for 2 seconds.
Voice Assistant (SIRI command)
Triple-click the MFB button (depends on mobile phone feature)
Audio Cable Operation
When Bluetooth headphones is connected to the device with a 3.5mm audio cable,
the Bluetooth function will automatically shutdown Unplugging the cable,
follow the pairing procedures for connection again.
Active Noise Cancellation (ANC)
Turn on ANC function: When ANC is off, toggle 8 ANC button to activate the
active noise cancellation function. When ANC is on, indicator stays green.
Turn off ANC function: When ANC is on, toggle 8 ANC button to deactivate the
active noise cancellation function.
Reset Paired Device List
When power on and no Bluetooth device connected, press and hold both “+” and
“-” buttons simultaneously for 5 seconds.
LED Indicator Guide
Listen Responsibly
To avoid hearing damage, make sure that the volume on your music player is
turned down before connecting your headphones. After placing headphones in/on
your ears, gradually turn up the volume until you reach a comfortable
listening level. Noise levels are measured in decibels (dB), exposure to any
noise at or above 85 dB can cause gradual hearing loss. Monitor your use;
hearing loss is a function of loudness versus time. The louder it is, the less
time you can be exposed to it. The softer it is, the more time you can listen
to it. Get the most out of your equipment and enjoy great audio performance
even at safe levels.
Our headphones will allow you to hear more details at lower volume levels than ever before. Learn how to establish a safe listening level and review other important safety guidelines from the Consumer Electronics Association atwww.ce.org. Important information on how to prevent Noise-Induced Hearing Loss (NIHL) and a comprehensive list of which noises can cause damage can be found on the Deafness Research Foundation’s website, www.drf.org.
Precautions
- Charging every 15 days will extend battery life when not in use often. Cleaning off dirt on the charging contacts by cotton swabs with alcohol will maintain a good contact for charging.
- Keep battery (battery pack) away from inflammables or excessive heat such as direct sunlight.
- Intermittent is normal during playback for wireless products due to environmental factors, device brand, users’ behavior, etc.
Warnings
- Do not use headphones at high volume for an extended period of time.
- Keep the headphones away from dust and water.
- Do not disassemble the headphones and accessories, otherwise warranty will be voided.
- Keep headphones away from any impact or vibration.
- Do not use any chemical solvents or cleaning agent on the headphones.
This table is compiled according to SJ/T 11364.
O: Indicates that this hazardous substance contained in all of the
homogeneous materials for this part is below the li mi requirement in GB/T
26572.
X: Indicates that this hazardous subatance contained in at least one of
the homogeneous materials used for this port is above the limit requirement in
GB/T 26572.
Environment Friendly Use Period (EFUP)
Warranty Service
Wear uses les to fility and is te it for of vre future warranty applicatio n
please coperate.
FCC Warnning
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution
Any changes or modifications to this device not explicitly approved by
manufacturer could void your authority to operate this equipment. This device
complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: This device may not cause harmful interference, and this
device must accept any interference received, including interference that may
cause undesired operation. This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 0cm between the radiator and your
body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>