artecristal Grifo TIBER Lavabo Instruction Manual
- June 12, 2024
- artecristal
Table of Contents
artecristal Grifo TIBER Lavabo Instruction Manual
GENERAL INFORMATION
Stainless steel body: durable and ideal for prolonged contact with water.
Ceramic Valve Cartridge: Ensures smooth operating life of the handle and drip-
free performance.
Minimum lead content: does not affect water quality. Straight lines: elegant
and modern image.
TECHNICAL SPECIFICATIONS
**** Recommended water pressure 0.1~ 0.5MPa Test pressure: 0.9MPa
Recommended cold water temperature: 2-29º C Recommended hot water temperature:
55-85 ºC
Note: The pressure difference between cold and hot water should not exceed 0.1
MPa.
ATTENTION
**** This product has been tested and adjusted by the company, please do not
disas- semble without authorization, as it may damage its original operation.
Please always rely on experienced professionals to install the product.
Regarding the installation of the faucet, you should try not to hit it with
hard objects or let the glue or cement come into contact with the product as
it may damage the original coating.
Please note that you should first clean the residues inside the pipe before
insta- lling the tap, in order to avoid clogging due to dirt that could affect
the use of the product.
After installation and use of the product, it is advisable to use a wrench to
uns- crew the nozzle and rinse impurities.
Finally, check that all connections are tight to avoid leaks.
MAINTENANCE
Clean the faucet and showers as and when necessary. Regular cleaning can pre-
vent calcification.
Never use cleaning products containing hydrochloric acid, formic phosphoric
acid or acetic acid, as they can cause considerable damage.
Never use cleaning products or equipment that have an abrasive effect, such as
sponges, microfibre cloths or unsuitable cleaning powders.
After cleaning, rinse the faucet thoroughly with clean water to remove any
clea- ning residue.
Unscrew and clean the aerator regularly.
ASSEMBLY / DISASSEMBLY CARTRIDGE
- Close the hot and cold water
- Remove the rubber plug (C) at the back of the
- Loosen the setscrew (D) located on the side of the
- rear lever
- Remove the lever (E).
- Remove the housing (F) (not threaded).
- Loosen the threaded ring (G).
- Remove the cartridge (H).
The cartridge seals (H1) must fit snugly into their housings on the single- lever body.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>