blinds2go Orla Kiely Multi Stem Blinds Installation Guide
- June 4, 2024
- blinds2go
Table of Contents
Orla Kiely Multi Stem Blinds
Installation Guide
We’ve made a handy video version of this fitting guide, just click the play
button to view it.
If you prefer to print the instructions or simply follow them step-by-step,
just keep reading.
Fitting the brackets
The brackets offer two methods of installation:
|
---|---
Where the brackets are screwed into the lintel (or ‘ceiling’ of the recess)|
Where the brackets are screwed onto a facing surface (a wall or window frame)
Note that the position of the outermost brackets should be at least 5cm away from the ends of the rail, with any other brackets evenly distributed across the width.
Fitting the blind
|
---|---
Situate the front lip of the headrail into the front of the bracket.| Push the
back of the headrail upwards to lock it into the back of the bracket.
Operating the blind
Pull down on the front part of the chain to lower the blind, and pull down on the rear part of the chain to raise the blind.
Top Tip
If you find at any point that the blind has fallen to one side, the likelihood
is that this has been caused by a simple mix-up with the controls, in that
they may have been pulled the wrong way to either raise or lower, which can
cause the cords to roll up unevenly. To fix this, simply use the front of the
chain to fully lower the blind, then continue pulling the chain until it
raises to the top. The blind should even itself out as you do, and you can
prevent the same issue from occurring again by making sure the chain is always
pulled in the correct direction from that point forward.
Child Safety
WARNING
Young children can be strangled by loops in pull cords, chains, tapes, and
inner cords that operate the product.
To avoid strangulation and entanglement, keep cords out of the reach of young
children. Cords may become wrapped around a child’s neck.
Move beds, cots, and furniture away from window-covering cords.
Do not tie cords together.
Make sure cords do not twist and create a loop.
The cord-retaining device must be installed at the maximum distance possible
from the control mechanism to prevent looped cords from becoming slack.
Place the retaining device on the wall and mark the position of the screw
hole(s) with a pencil.
Attach the retaining device to the wall using the fixings provided.
Additional Information
Removing the fabric for cleaning
If you need to remove the fabric, to take it to a dry cleaner for example,
then that’s easy.
The fabric attaches at the front with velcro, simply peel the
fabric away from the headrail.
At the back, the cords are attached to the fabric using clips, which double as a child-safety feature. These clips are in two parts and can be easily unclipped to separate the cords from the fabric.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>