WESTGATE TECHNOLOGY CRS1 X1 Speaker Installation Guide
- June 12, 2024
- WESTGATE TECHNOLOGY
Table of Contents
WESTGATE TECHNOLOGY CRS1 X1 Speaker
Installation List
- Power Cable1 x 1 – CRS1 x 1 – Power Cable2 x 1
- Product Introduction: – Power Key – VOL+ – Logo – Play Pause Power
- LED – VOL- – QR Code – Interface Definition: – Power – USB
Installation Instructions
- Unpack the machine and fix it to the frame first.
- After installing the machine, install the power cord on the machine and install the loading cable on the vehicle.
- Installing the wire, modifying the wire cover, and fixing it with screws. Specifications: – Button: Power, Up, Down, Play & Pause
- Speaker (spk) – 415W x 2 – USB – USB2.0-B x 1 – DCIN – Interface BT – Supports 24V – 80V DCIN – Right SPK Harness –
- DCINUSB Audio Cable – Left SPK
- Harness – Audio Cable – Supports Bluetooth 5.0
- compatible with Bluetooth 4.2 / 4.0 / 2.1 + EDR system
Product Introduction
interface definition
Installation instructions
- Unpack the machine and fix it to the frame first
- After installing the machine, install the power cord on the machine and install the loading cable on the vehicle
- Installing the wire, modifying the wire cover, and fixing it with screws
spec
IO| button| power 、 up 、 down 、 Play
&pause
---|---|---
spk| 4Ω15W X2
USB| USB2.0-Bx1
DCIN
| ****
**** support 24V–80V DCIN
Interface
| ****
Right SPK Harness ： DCIN、USB、Audio cable Left SPK Harness： Audio cable
BT| Support Bluetooth5.0,
compatible with Bluetooth4.2 /4.0/2.1 + EDR system
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with a minimum distance between 20cm of the radiator and your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>