ISEO 200N Mortice Lock Instructions

200N Mortice Lock
Instructions

200N MORTICE LOCK

200N Mortice Lock

1. Use drilling template (see reverse) or hold the lock at the required position.
   Draw horizontal lines on the door edge marking the top and bottom of the lock body.

2. Mark a vertical line at the centre of the door edge between the two horizontal lines.
   Using the attached drilling template and a router, cut out the shape of the lock body from the face of the door and predrill and tap the top and bottom mounting holes at ø4mm.

3. Use drilling template (see reverse)
   Prepare the hole. Fit the lock and cylinder and ensure that the bolt works correctly. Screw the lock into position.

4. On the door frame, mark the top of the roller bolt or latch bolt and the bottom of the deadbolt.

5. Using these guidelines check out and fit the striker plate.
   Ensure tongue of striker plate is around the correct way, depending on the handing of the door.

6. FIT HANDLE.
   Fit handle as per manufacturer’s instructions.

200N MORTICE LOCK HANDING REVERSAL

CHECK HANDING
Determine if handing direction is correct for the door Installation. If reversal is needed follow these steps to reverse handing direction.

RELEASE LATCH
Using a screw driver, firmly push the latch past the lock face.

REVERSE LATCH
With the latch protruding past the lock face, turn the latch 180 degrees and reseat the latch into the lock face.

Note: If reprinting this template, ensure you print 1:1 ratio, and double check the drilling template with an accurate ruler.

P: +64 9 444 5359 | F: +64 9 444 3972 |
sales@gdrutter.co.nz | www.sylvan.co.nz
ISEO200N0001

Documents / Resources

| ISEO 200N Mortice Lock [pdf] Instructions
200N Mortice Lock, 200N, Mortice Lock, Lock
---|---

References

• Sylvan Architectural Hardware

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>