SmartStraps 1500 LB Ratchet Strap Instruction Manual

SmartStraps 1500 LB Ratchet Strap

Product Information

1,500 LB Ratchet Strap

The 1,500 LB Ratchet Strap is a product designed to secure cargo during transportation. It has a safe working load limit of 500 lb (227 kg) and is manufactured by Winston Products Company. The product is available for purchase at retailers or online at smartstraps.com. The product comes with installation instructions and warranty information.

Product Usage Instructions

1. Read and observe all warnings, instructions, and capacity limitations before using the product.
2. Ensure that the split axle is turned less than 1-1/4 turns before using the product.
3. Place the strap over the cargo and hook the ends onto the anchor points.
4. Tighten the strap by pulling the loose end of the strap while holding the ratchet handle.
5. Continue tightening until the cargo is properly secured.
6. Close the ratchet handle fully to lock the mechanism.
7. To release the strap, pull the spring-loaded pawl in the handle and open the ratchet a full 180 degrees.

If you experience any problems with your SmartStraps product, do not return it to the retailer from which it was purchased. Instead, call 1-844-295-9218 for assistance with any problems.
Warranty information is available upon request and can be found online at smartstraps.com.

INSTALLATION INSTRUCTIONS

WARNING: Read and observe all warnings, instructions, and capacity limitations before using this product.
Failure to comply with this warning and the associated instructions and capacity limitations may result in serious personal injury and/or significant property damage.

INSTRUCTIONS:

1. Attach the hook WITHOUT Ratchet mechanism to a suitable anchor point.
2. Pass webbing over cargo.
3. Attach hook WITH Ratchet mechanism to a suitable anchor point.
4. Pass free end of webbing through split axle of Ratchet and pull to remove slack.
5. Pump Ratchet handle to tension webbing while being careful not to over-tighten.
6. Rated capacity is based upon 1-1/4 – 1-1/2 turns of the split axle while tensioning the webbing. Tie down must be re-tensioned if the split axle turned less than 1-1/4 turns.
7. Once cargo is properly secured, close Ratchet handle fully to lock the mechanism.
8. To release, pull spring loaded pawl in handle and open Ratchet a full 180 degrees.

IF YOU EXPERIENCE ANY PROBLEMS WITH YOUR SMARTSTRAPS PRODUCT DO NOT RETURN THE UNIT TO THE RETAILER FROM WHICH IT WAS PURCHASED. INSTEAD, PLEASE CALL 1-844-295-9218 FOR ASSISTANCE WITH ANY PROBLEMS. WARRANTY INFORMATION IS AVAILABLE UPON REQUEST AND CAN BE FOUND ONLINE AT SMARTSTRAPS.COM.
WINSTON PRODUCTS COMPANY SMARTSTRAPS.COM WINSTON PRODUCTS, LLC. 30339 DIAMOND PARKWAY ©05/2022 CLEVELAND, OH 44139

References

• SmartStraps -

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>