Fantadool WB-2WB Dynamo Hand Crank Radio with Reading Lamp Instruction Manual
- October 30, 2023
- Fantadool
Table of Contents
Fantadool WB-2WB Dynamo Hand Crank Radio with Reading Lamp
Product Information
- LED Reading Lamp
- Antenna
- Flashlight ON/OFF
- Flashlight SOS LAMP
- DC IN 5 V
- TF CARD
- USB OUT 5V
- Earphone Jack
- Solar Panel
- Charging Indicator
- Tuning Indicator
- Tuning VOL+/LIGHT ON/OFF/SOS
- USB/TF CARD/BT Prev /Next/Play/Pause
- OFF/FM/AM/WB/BT Output Power Indicator Speaker
- Hand Crank
PRODUCT SPECIFICATION
- Product Charge RMS AM FM AM/FM/WB Dynamo Hand Crank Radio With Alert/ SOS/ Torch/ Reading lamp/ Phone Charger/ Solar Panel With charge and discharge protection lack
- 5Wx1 520 – 1710KHz
- 87 – 108MHz
- WB:162.400MHz/162.425NHz/162.450MHz/1 62.475MHz/162.500Mhz/162.525Mhz/16 2.550MHz
- USB/TF: USB/TF Card MP3 Paly, BLUETOOTH Paly
- 4 Ways to Charge Flashlight: LED Solar Panel/ Hand Crank/ Built-in lithium battery. Flashlight range 300M
- LED reading lamp 300LM
- Phone jack Battery Input: 3.5mm Phone jack 3.7V 4000Ma DC 5V2.0A
- Output: DC 5V 2.0A
- Unit Size: 16.06.68.2cm
- Unit Weight: 400g
Product Usage Instructions
To use the product, follow the instructions below:
Charging the device:
- Charge using the DC IN 5 V input with a compatible charger.
- Charge using the solar panel by placing it under direct sunlight.
- Charge using the hand crank by rotating it clockwise for several minutes.
Using the radio:
- Turn on the radio with the ON/OFF button.
- Select the desired frequency band (AM/FM/WB) with the OFF/FM/AM/WB/BT button.
- Tune to a specific frequency using the Tuning VOL+/LIGHT ON/OFF/SOS button and observe the tuning indicator.
Using the flashlight:
- Turn on the flashlight with the Flashlight ON/OFF button.
- Activate the SOS LAMP function with the Flashlight SOS LAMP button.
- Adjust the flashlight range using the Tuning VOL+/LIGHT ON/OFF/SOS button.
Using the LED reading lamp:
- Turn on the LED reading lamp with the LED Reading Lamp button.
- Adjust the brightness of the lamp using the Tuning VOL+/LIGHT ON/OFF/SOS button.
Using the USB/TF card/BT player:
- Connect a USB/TF card or activate Bluetooth mode using the USB/TF CARD/BT Prev /Next/Play/Pause button.
- Control playback using the USB/TF CARD/BT Prev /Next/Play/Pause button.
Using the phone charger:
- Connect a phone to the device using the Phone jack.
- The device can charge a phone with DC 5V 2.0A output.
Overview
SPECIFICATION
Product| AM/FM/WB Dynamo Hand Crank Radio With Alert/ SOS/ Torch/ Reading
lamp/ Phone Charger/ Solar Panel
---|---
Charge| With charge and discharge protection lack
RMS| 5Wx1
AM| 520 – 1710KHz
FM| 87 – 108MHz
WB| 162.400MHz/162.425NHz/162.450MHz/1
62.475MHz/162.500Mhz/162.525Mhz/16
2.550MHz
USB/TF| USB/TF Card MP3 Paly
BLUETOOTH| BLUETOOTH Paly
4 Ways to
Charge
| Solar Panel/ Hand Crank/ Built-in lithium
battery.
Flashlight| Flashlight range 300M
LED| LED reading lamp 300LM
Phone jack| 3.5mm Phone jack
Battery| 3.7V 4000Ma
Input| DC 5V 2.0A
Output| DC 5V 2.0A
Unit Size| 16.06.68.2cm
Unit Weight| 400g
FCC
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>