Vertex Standard BU-2 Bluetooth Adapter Unit User Manual

: June 10, 2024
: Vertex Standard

Table of Contents

Bluetooth Adapter UnitBU-2
Standard BU-2 Bluetooth Adapter Unit
VERTEX STANDARD CO., LTD.
Documents / Resources

Bluetooth Adapter UnitBU-2

User Manual

Standard BU-2 Bluetooth Adapter Unit

The “BU-2″ is a Bluetooth- Adapter Unit for Vertex Standard Transceivers. When the Bluetooth’ headset -BH-1/A”, “BH-2/A” is used with the -BU-2- Adapter, you can enjoy com-fortable hands free operation.
: Please refer to the Vertex Standard catalog for the correct “BU-2” Adapter for the radio you are using.
This Bluetooth® radio module has to be installed and used in accordance with the technical descrip-tion/installation instructions provided by the manufacture.
This Bluetoothe radio module is intended to be placed on the market in all States, where the Bluetooth® technology and the used frequency band is released.
For detail information concerning type approval of this module (e.g. where this module is already pre-approved) please contact the manufacturer.
The system may only be implemented in the configuration that was authorized.
Note that any changes or modifications to this equipment not expressly approved by the manufac-turer could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Part 15.21: Changes or modifications to this device not expressly approved by Vertex Standard could void the user’s authorization to operate this device.
CAUTION: This device and its antenna(s) must not be co-located or operated in conjunction with any other antenna or transmitter. End users cannot modify this transmitter device. Any unau-thorized modification could void the user’s authority to operate this device.
‘To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons.
The term “IC” before the radio certification number only signifies that Industry Canada technical specifications were met.
This device complies with RSS 210 of industry Canada “IC”. “Operation is subject to the following two conditions:

this device may not cause interference, and
this device must accept any interference, including interference that may cause undesired operation of the device.

The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in excess of Health Canada limits for the general population; con-sult Safety Code 6, obtainable from Health Canada’s website www.hc-sc.ca/rpb”
Labeling: When the module is installed into the system, the following information shall be placed on the outside of final host system.
Contains FCC ID: K660H464X10 IC : 511B-0H464X10