JBTEK H40 True Wireless Bluetooth Earphones Instruction Manual

JBTEK H40 True Wireless Bluetooth Earphones Instruction Manual

Packing list

Tip_s

1. Except for the operation methods specifically marked in the manual,please do not try to disassermble or replace any parts in the earbuds.

2. Don’t put the earbuds in the water or any others liquid. Theearbuds are not waterproof.

3. If any liquid enters the product by accidentally,please disconnect and remove the connection immediately.

4. Please make sure that there is no water on your hands when
   Installing or uninstalling the product to avoid electricshock.

5. Do not put the product near by the heat source or expose it to the fire source directly.

6. Do not put the product in the environment with strong electro magneticforce, otherwise it will cause product malfunction.

Earphones specifications

Bluetooth version: V5.3
Transmission distance: 10M
Music time : About 5 hours Horn size : Φ6mm
Charging time : 1.5 hours Battery capacity: 30mAh Rated input: 5V30mA

Charging’ case specifications

Battery capacity: 230mAh Charging time: 1.5 hours Battery voltage: 3.7V
Rated input: 5V300mA
(All technical information is subject to actual performance)

Charge the Earphones

1. When the battery of the earphones is too low, the earphones will broadcastareminder of low battery every minute until the earphone shuts down(Voice prompt: “Battery low” ), in this case please charge the earphoneintime. 1.
2. When the charging case has sufficient charge, put the earphonesbackintothe charging case, the earphones will enter the charging state, thewhitelightofthe earphones will turn on.
   Then the earphones will be full chargedabout1.5hours later, and the white light of the earphone will turn off.

Charge the Charging Case

Use the included USB-C cable to charge the chargingcase, whichwilltake about 1.5 hours to complete.

LED Indicator of the charging case

Operation Instructions

Power on
Method 1: Take both earphones out from the charging case, it will be power on automatically.
Method 2: Long press the left and right earphones touch button for 2 seconds. (Voice prompt: “Power on”)
Note: The earphones will shut down automatically when they are either not connected or not in use for 5 minutes.
②Power off
Method 1: Put both earphones back into the charging case, it will enter charging status and shut down automatically after fully charged.
Method 2: Long press either earphone touch button for 5 seconds, then both the left and right earphones will be turned off at the same time.(Voice prompt: “Power off”)

③Pairing
Step 1: Take out both earphones from the charging case, the earphones will power on and enter pairing mode automatically. (Voice prompt: “Pairing”)
Step 2: At this time turn on the Bluetooth function of your device and search for “H40” Then press “pair” , the earphones will connect to your device successfully.
(Voice prompt: “Connected”)

Touch operation

LED Indicator of the Earphones

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>