SHAN TOU CHENGHAI HAIZHI SEN TOYS FACTORY STUNT CAR Instruction Manual
- June 5, 2024
- SHAN TOU CHENGHAI HAIZHI SEN TOYS FACTORY
Table of Contents
SHAN TOU CHENGHAI HAIZHI SEN TOYS FACTORY STUNT CAR
TRANSMITTER
BATTERY CAUTION
- THIS PRODUCTS USE 4 PCS 1.5V “AA” BATTERY, THE REMOTE CONTROL USES 2 PCS 1.5V “AA” BATTERY.
- PLEASE INSERT THE BATTERY WITH THE CORRECT POLARITY.
- PLEASE DO NOT MX USE NEWAND USED BATTERY.
- USE THE SAME OR EQUIVALENT TYPES OF BATTERY ONLY.
- DO NOT SHORT CIRCUITTHE BATTERY.
- PLEASE REMOVE THE EXHAUSTED BATTERY FROM THE PRODUCT.
- DO NOT CHARGE NOT RECHARGEABLE BATTERY.
- CHARGING THE BATTERY NEEDS PARENT SUPERVISION.
- CHARGE THE BATTERY WHEN THE BATTERY S INSTALLED ON THE PRODUCT.
- PLEASE CLEAN THE PRODUCT WITH A DRY AND SOFT CLOTH.
- DO TRY TO SNAP THE ANTENNA.
BATTERY INSTALLATION
FREQUENCY
- UNDESIRED cONTROL MAY HAPPEN IF OTHER RADIO TOYS OF THE SAME FREQUENCY IS USED NEAR BY.
- UNDESIRED CONTROL MAY ALSO HAPPEN IF ANOTHER RADIO PRODUCT IS USED NEAR BY PLEASE GO TO OTHER PLACES
- THIS PRODUCTS IS FOR CEMENT SURFACES. OTHER SURFACES MAY CAUSE 180 DEGREE TURNING OR SPINNING.
HOW TO CONTROL
- If you make the car go backward and suddenly press the go forward button the car will stand up and use two rear wheels and the tall wheel to do stunts.
Note: If the car slows down, It means the battery is low and needs to replace the batteries.
FCC WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by the manufacturer could void your authority to operate this equipment
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>