DETECT-IT 1014 Metal Detector Ear Children Lightweight User Manual

Table of Contents

The metal detector comes to you about to use. The only adjustments required are the length of the stem and the angle of the search coil.

Turn the stem’s locknut clockwise until it
Adjust the length of the stem so that you can walk comfortable with the search coil at optimal distance of around 1/2 to 2 inches above the
Retighten the stem’s lock nut counter-clockwise to lock it in

Loosen the knobs at the search coil and rotate the coil angle until it is parallel with the ground.
Tighten the knobs so that it is just enough to keep the search coil from rotating or

Loosen the screw with a screwdriver, then remove the battery compartment
Identify the polarities of a 9 volt battery and the polarities marked inside the Insert the battery into the compartment in the same direction as indicated by the marks.

Erect the LCD ○5 .
Push the power switch ○1 to turn on the detector. At this time, green LED ligh
This means the detector is ready for operation. Meanwhile LCD displays . Slide down the power switch to turn off the detector.
Hold the detector in a comfortable position with the search coil in parallel with a ﬂat surface where there is no metal
Place a sample of coin on the ground, sweep the coil in side to side motion to ﬁnd the sample.
During searching, LCD displays . When the detector ﬁnds a metallic object, red LED lights, beep sounds will be heard and LCD displays
When LCD displays , replace the battery.

The detector comes with motion detection mode. For finding metal targets, youhave to move the coil or move the metal sample above the coil.
Sweep the search coil in a side-to-side motion
Take your time. You may miss a target if you walk too fast. Never sweep the search coil as if it were a pendulum.

Keep the detector away from dust and dirt, which can cause premature wear of
Wipe the detector with a damp cloth occasionally to keep it looking Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the detector.
Remove exhausted battery to avoid
Handle the detector gently and carefully. Dropping it can damage circuit board and cases and can cause the detector to work improperly.

Read User Manual Online (PDF format)