ROWENTA DA1510 Fordable Iron Steam Instruction Manual
- June 6, 2024
- Rowenta
Table of Contents
ROWENTA DA1510 Fordable Iron Steam
OVERVIEW
SAFETY INSTRUCTIONS
- Please read these instructions carefully and keep them for further
- Never leave the appliance unattended when it is connected to a power source; if it has not cooled down for approximately 1
- The iron must be used and rested on a flat, stable, heat-resistant
- When you place the iron on the iron rest, make sure that the surface on which you place it is
- Always unplug your appliance: before filling, or rinsing the water tank, before cleaning it, after each
- Children must be supervised to ensure that they do not play with the
- Keep the iron and its cord out of reach of children less than 8 years of age when it is energized or cooling
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they have been given supervision or instruction concerning use of the appliance in a save way and understand the hazards
- Cleaning and user maintenance shall not be made by children without
- The appliance must not be used if it has fallen to the floor, shows evident of damage, leaks or fails to function correctly. Never dismantle you To avoid any danger, have it inspected in an approved service centre.
- The surfaces which are marked with this sign and the soleplate are very hot during the use of the appliances. Don’t touch these surfaces before the iron is cooled
- The iron is not intended for regular use.
IMPORTANT RECOMMANDATIONS
- The voltage of your electrical installation must correspond to that of the iron (220-240V). Always plug your iron into an earth socket. Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee.
- If you are using a mains extension lead, ensure that it is corrected rated (16A) with an earth, and is fully extended.
- If the electric power cord is damaged, it must be replaced by an Approved Service Centre in order to prevent any danger.
- Do not unplug your appliance by pulling on the cord.
- Never immerse your steam iron in water or any other liquid. Never hold it under the water tap.
- Never touch the electric cord with the soleplate of the iron.
- Your appliance gives off steam, which may cause burns, especially when you are ironing close to the edge of your ironing board.
- Never direct the steam towards people or animals.
- For your saftey, this appliance conforms to the applicable standards and regulations (Low Voltage, Electromagnetic Compatibility, Environmental Directives).
- This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.
ENVIRONMENT PROTECTION FIRST
- Your appliance contains valuable materials which can be recovered or recycled.
- Leave it at a local civic waste collection point.
DESCRIPTION
- Voltage selector (120/240 V)
- Temperature control
- Steam switch
- High precision tip
- Microsteam200 soleplate
- Handle water tank
- Water filling inlet
- A burst of steam button
- Handle release
BEFORE IRONING
Remove the sticker on the soleplate. Adjust the voltage selector.
- Adjust the iron to correct voltage for your location, using a sharp object. If the voltage selected is 120 V, the iron will operate at 110 – 127 V. If it is set at 240 V, the iron will operate at 220 – 240 V.
Note
If necessary, check that you are using an adapter that meets the safety
requirements of the country you are in.
Put the handle into the ironing position
- Press the release button on the rear side and raise the handle until it locks into position.
- For storing proceed in the same way to close the handle.
STEAM IRONING
Filling the water tank.
Your iron has been designed to operate using untreated tap water.
Setting the temperature
Note
Your iron will only produce steam when the control is set within the coloured
zone.
**USING BURST OF STEAM AND VERTICAL STEAM
**
- To remove creases vertically. Hold the iron a few centimeters away from the garment to avoid burning delicate fabrics.
- IMPORTANT Never direct the steam at people or animals.
DRY IRONING
Our advice:
With the iron in DRY mode, start by ironing fabrics at a low temperature (•)
before moving on to those requiring a higher temperature.
If you turn the temperature control down, wait for approximately one minute
before ironing again. If you are ironing fabrics made from mixed fibres: set
the iron temperature to the correct level for the most delicate fibre
.
MAINTENANCE AND STORING OF YOUR IRON
Cleaning your iron
- Note! Make sure the iron is cold before storing it. Do not use any cleaning or descaling products.
- IMPORTANT Do not wind the cord around the hot soleplate. Never store your iron placed down on the soleplate.
Storing your iron
Problems
and possible causes
| Solutions
---|---
Your iron produces little or no steam
• The temperature selected is too low.
• The steam control is set on OFF.
• There is no water in the tank.
| Set the temperature control on ••• Switch the steam control to ON. Fill the
water tank.
Water is dripping from the holes in the soleplate
• You have been using the burst of steam button too often.
• Steam is used before the iron is hot enough.
• The iron is stored with water in th tank.
| Wait a few seconds between each shot.
Set the thermostat within the coloured steam zone and wait until the iron is hot (approx. 2 min.).
Empty the tank before storing the iron and set the steam control to OFF.
• The problem persists.| Take your iron to an Approved Service Centre.
HELPLINE
if you have any product problems or queries, please contact our Customer Relations Team first for expert help and advice: 0845 602 1454 – UK (01) 677 4003 – Ireland or consult our website – www.rowenta.co.uk
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>